Filter
Top Products
9
8
Caring for Your Iron and Soleplate
1. The Water Tank of your iron should
be emptied after each use. Turn
Temperature Control Dial to OFF.
Unplug the iron and hold over a
sink. Turn iron upside down until
Water Tank Opening is parallel with
sink. Water will run out of water
tank opening.
2. After iron has completely cooled,
wrap cord loosely around the iron and store in an upright
position. Do not store iron laying flat on soleplate.
Soleplate
1. Never iron over zippers, pins, metal rivets, or snaps, as
these may scratch the soleplate.
2. To clean occasional build-up on the soleplate, wipe with
a sudsy cloth. Do not use abrasive cleansers or metal
scouring pads.
3. Always store iron upright in the heel rest position.
Troubleshooting
Won’t
heat
PROBLEM
THINGS TO CHECK
Water is
leaking
Won’t
steam
Leaves
spots
• Is the iron plugged in and the outlet working?
Check the outlet by plugging in a lamp.
• Is the Temperature Control Dial turned to a
fabric setting?
• If automatic shutoff model, is light on? If not,
press Reset Button.
• Do not overfill the water tank.
• If steam ironing, is Adjustable Steam Switch in
a steam position, the Temperature Control Dial
in the steam range and did the iron have
enough time to preheat?
• If dry ironing, make sure the Adjustable Steam
Switch is in the DRY IRON position.
• Check the water level.
• Is the Adjustable Steam Switch in the STEAM
position?
• Has the iron had enough time to preheat?
• ALWAYS empty the water tank of the iron
after using. Water left in the tank may discolor
clothing and soleplate.
• If the iron cord should become twisted, unplug
iron and let cool. Hold iron cord in the middle
of entire length. Let plug and iron dangle freely
until cord uncoils. This will extend the life of
your iron cord.
Twisted
cord