Hamilton Beach 840091300 Iron User Manual


 
6
Spray and Blast of Steam Buttons
Push Blast Button for an extra blast of
steam. Push Spray
Button to release a
fine spray of water
for difficult wrin-
kles in cotton or
linen.
Auto Shutoff Reset Button/Light
The light comes on when the iron is
first plugged in.
After one hour,
the iron will shut
off and the light
will go out. Push
the Reset Button/
Light to turn the
iron back on.
Power Light
This light comes on when the iron
is plugged in
and remains on
until the iron is
unplugged. The
light stays on even
if Temperature
Control Dial is
turned to Off.
Adjustable Steam Knob
This knob provides minimum steam for
wool or maximum
steam for linen.
Set the knob to
to change to Dry
Iron.
Power
Light
Optional Features (on selected models)
Blast Spray
Self-Clean
1. Fill iron with water. Plug in iron.
2. Turn Temperature Control Dial to
Linen setting and let iron heat for
2 minutes.
3. Turn Temperature Control Dial to Off.
Unplug iron and hold over a sink
with the soleplate facing down.
4. Turn Adjustable Steam Knob to
(Self-Clean). Hot water and steam
will flow out of steam vents.
5. Allow all water to drain from iron,
then let cool and store.
To keep the steam vents clear of any build-up, follow these instructions after each
time you use the iron using steam.
840091300 ENv01 9/24/01 4:33 PM Page 6