Filter
Top Products
The washing machine away from wall should be overrun 20mm.The largest allowable slope of the shank base of
the machine is 2 .The slanting or rough ground will result in unstable running or stoppage of the machine.
Please adjust it with following methods:
Confirm it's horizontal:
Hang the lead line to check if it is
horizontal.
Adjust the adjustable leg:
Install the bottom plate
Adjust the Installation position
Screw
Back
Front
bottom plate
Soft object
FastenLoosen
High
Low
the adjustable nut
the adjustable foot
Please install and adjust the machine according to the requirement of the mannual.
It is very important to your security and correct operating the machine.
Before Using
Before Using
Installation and adjustment
1 .To twist the adjustable leg, please first lift up the
side of the leg slightly, loosen the adjustable nut,
and twist the leg.
2 . After adjustment, fasten the nut.
After opening the package, please lean the washing
machine gently down on soft items (like towel cloth,
blanket, etc.). Installthe bottom plate to the bottom of
the machine with eight screws by a cross screwdriver,
then lift the machine up gently. (See to the figure)
1.Open the top lid of the washing machine.
2.Put the inner cover component on the outer tub cover, aiming
the inner cover shaft to the installation hole of the corresponding
outer tub cover shaft groove.
3.Firstly insert the inner cover shaft of one side into the correspon
-ding outer tub cover shaft groove, then push the another inner
cover shaft into the corresponding outer tub cover shaft groove.
Please install to designated position to guarantee there are no
dropping or abnormal sound in opening and closing of the inner
cover, and the operation shall be smooth. Do not dismount the
inner cover component after washing.
4.Install the lint filter in the balance ring.(See to the right figure)
Inner cover
Inner cover shaft
Outer tube cover
Install the lint filter
Install the inner cover and lint filter