Haier WM6002A Washer User Manual


 
Push the "START/PAUSE"button
5 Close the lid
6 Finish washing
After Finishing wash
alarm automatically
After finishing wash it'll alarm automatically
As the top lid opened ,the Washer will automatically give an alarm
and stop running , exclusively during supplying water and rinsing.
Using process
Using process
* Total time: including the normal water inlet time and drain time. The total washing time may be influenced by
the water inlet pressure and water level.
* Spin time: From the moment the intermittent spinning starts to the moment it stops running (the time displayed
on spin digitron is from intermittent spinning to the moment before inertia spinning; the time displayed on the
time remain digitron is the total remaining time)
* In soaking, after water inlet it will perform soaking for about 10-40 minutes, then perform washing, rinsing and
spinning.
* In selecting "pasthaste" program, the washing machine will set the complete procedures of water level
selector, washing, rinsing and spinning automatically.
Push the "RESERVE" button to select suitable reserve wash program
START
PAUSE
After switching on the power, the reserve program is set to off mode automatically. If you need to set the washing
procedure to be finished at reserved time, please push the " reserve " button to set the reserve wash program.
Refer to reserve button in Page 11 for selection
When the "RESERVE " function is activated, the indicator light of the program you have
set will be off. The "reserve (hours later)" and "time remain (minutes) " indicator lights will
be on. During reserve procedure, push the "reserve" button to display the reserve mode.
To change the running program or cancel the reserve setting, you
need to switch off the power and make new selection.
the washing will be finished after 18 hours.
Confirm the operation of reserve program
RESERVE
Page
Time remianed
(minutes)
Reserve
(hours later)