Haier RDG350AW Clothes Dryer User Manual


 
6
INSTALLATION INSTRUCTIONS
WARNING
Risk of Fire
Clothes dryer installation must be performed by a qualified installer.
Install the clothes dryer according to the manufacturer's instructions
and local codes.
To reduce the risk of severe injury or death, follow all installation
instructions.
TOOLS NEEDED
Phillips Screwdriver
Flat-Blade Screwdriver
Channel-Lock Adjustable Pliers
½" Open-End Wrench
Carpenter’s Level
Measuring Tape (12 ft. [3.7 m] min.)
For gas installations only:
Pipe Wrench
2 Adjustable Wrenches
ADDITIONAL PARTS REQUIRED
4" (10.2 cm) Rigid or Flexible Metal Exhaust Ducting
Vent Clamps
Duct Tape
Power Cord (US Electric Dryer Only)
- A power supply cord kit must be purchased to meet local electrical codes.
The dryer must use a 3 or 4-wire NEMA 14-30 or 10-30 type SRDT or ST
(as required) power supply cord rated at 120/240 volt AC minimum,
30 amp, with 3 open-end spade lug connectors with upturned ends or
closed loop connectors and marked for use with clothes dryers.
- UL Listed Strain Relief
Gas Hookup Parts (Gas Dryer Only)
- ƍ" NPT Elbow
- ƍ" NPT Flare Adapter Fitting
- ƍ" Flexible Gas Connector
- Pipe-Joint Compound
Mobile Home Installation Kit (Gas Dryer for Mobile Home Only)