Filter
Top Products
17
1. Turn the gas supply oNj by moving the shut-oNj valve to the closed position.
Closed Valve
Open Valve
A
B
2. Disconnect and discard old Ǎ exible gas connector. Replace with a new
CSA(AGA) approved Ǎ exible gas connector.
3. Remove the shipping cap from the gas inlet pipe at the rear of the dryer.
4. Connect a ƍ" NPT elbow to the gas inlet pipe on the dryer. Then connect a Ǎ are
adapter to the elbow.
IMPORTANT: Use a pipe wrench to keep the dryer gas inlet pipe from twisting.
Gas Inlet Pipe on
the Dryer
³⁄₈" NPT Elbow
³⁄₈" NPT Flare Adapter
A
B
C
5. Connect the dryer to the gas supply line with a Ǎ exible gas connector.
Flexible Gas Connector
A
6. Tighten the Ǎ exible gas connector using two adjustable wrenches.
7. Turn the gas supply on by moving the shut-oNj valve to the open position. The
valve is open when the handle is parallel to the gas pipe.