Filter
Top Products
Install the bottom plate
After you open the package, please lean
the washing machine gently down on Soft
object ( like the towel cloth,blanket, etc. ).
Install the bottom plate to the bottom of the
machine with the eight screws by a cross
screwdriver, then lift the machine up gently.
See to the figure:
4
Please install and adjust the machine according to the requirement of
the mannual. It is very important to your security and correct
operating the machine.
Installation and adjustment
The largest allowable slope of the shank base of the machine is 2 .The
slanting or rough ground will result in unstable running or stoppage of the
machine. Please adjust it with following methods:
Confirm it's horizontal:
Hang the lead line to check if it is
horizontal.
Adjust the adjustable leg:
2
Adjust the Installation position
Fasten
Loosen
High
Low
the adjustable nut
the adjustable feet
1 .To twist the adjustable leg, please first
lift up the side of the leg slightly, loosen
the adjustable nut, and twist the leg.
2 . After adjustment, fasten the nut.
After opening the package, please take out the lint
filter from the document bag, install it to the inner
tub. See to the figure.
Install the lint filter
Inner tub
Lint filter
Drain hose
Ensure the drain hose si mounted at a suitable height.
( above the floor).
Do not poke it too far down the drain pipe or silphoning will occur.
Between 800-1200mm
Back
Front
Soft object
Screw
Bottom plate