Filter
Top Products
11
Use the operation buttons
Off
On: indicate the program about to run,or indicate
the selected mode or indicate the water level
Flashing: indicate the running program
It displays “--” during detecting.
It displays total remained time during the
running program (min).
It displays remained reserved time during
reserve program hour
It displays abnormal symbol in abnormal
situation.(See to Page 14)
Program Applicable situation
SOAK Washing the relatively big thick or very
dirty laundries
STANDARD Common washing
If “STANDARD” program is set, the
machine will execute fuzzy detection. The
computer will set the water level and wash
time as per the cloth and quantity of the
laundries. The whole procedure is under
automatic control.
SOFT Washing the woollen textiles
QUICK Posthaste wash of the laundry under 2.0
kg with light soil.
The water level will automatically set 38L .
WASH Just run the washing cycle with
out
drainage cycle. The detergent was left
inside the drum and can be recycled.
RINSE Remove the left detergent from the clothes
and then rinse the clothes
SPIN When the clothes are washed or the
clothes are quite wet, extra spin is needed.
TUB DRY The purpose is drying the inner tub and
the outer tub, which can avoid growing
After the power is switched on,press it to start
the machine.
During working, push it to pause.
During pause, push this button to restart
and go on working
Push the On/Off button to switch on the
power.
When the power is on, push it again to
switch off the power. Push the
On/Off button to switch on the power.
If the start/pause button is not pushed, the
washing machine will automatically switch
off the power after 5 minutes.
The digitron displays the time remained
(in minute) before the washing is fi nished.
Push down the reserve button. The reserve
indicator light is on the digitron displays the
reserve time of fi nishing washing (in hour).
When the machine is started, the reserve
indicator light is on, indicating that the
reserve function is running.
66L 72L
54L 60L
38L 46L
20L 29L
The washing machine can detect the
laundries automatically during After detection,
it will set the water level to suitable value
among 46L 60L 72L automatically during the
STANDARD program.
The water level decided may be different from
actual value because of the different moisture
level of the laundries.
You can also set water level by yourself. After
the machine is started, it will not set water
level automatically. You shall push the
start/pause button to make new setting.
If there’s water inside the
tub, the machine
cannot detect the laundries and will display
water level 60L.If wet laundries are put in, it
may display water level 72L. You must set
suitable water level by yourself.
If quick program is selected, it will display
water level 38L.
If tub dry program is selected, the water
level will not respond.
During operation of wash and rinse program,
you can push down the waterlevel button to
add water. When you release the button, or it
reaches the overfl ow water level, the machine
will stop adding water.
Rinse water level is more first level than
washing (except the highest water level and
hand choosing rinse water level).