Filter
Top Products
If you open the top lid,the machine will stop working and alarm in
spinning process.
4. Close the top lid
The capacity of washing of the machine refer to the largest weight of the standard
laundries under dry condition that can be washed in one time. Laundries quantity
in one washing cycle shall be lower than the rated capacity.
The thickness ,size , type of the cloth will influence the actual washing capacity.
It is suitable to put inreasonable amount of laundries and the laundries can be turned
round in washing for one time washing.
Do not select more than "4" water level for laundries less than 1.0kg ,so as to avoid
splashing of water.
2.Put in the laundries
How to use washing powder
Washing powder with poor quality or long-time storage may
get caked. Please clean the detergent box duly in usage.
Dissolve directly inside the washing machine: (not applicable
for fuzzy and reserve program)
1.Add some water(select the "1" water level)
2.Add washing powder. Run for about 30s to fully dissolve
the powder.Then push the"start/pause" button.
3.Put in laundries. Select suitable water level. Push the
"start/pause"
button again.
Quick dissolving of washing powder:
1.Prepare warm water of 30 C and container.
2.Add washing powder while stirring to dissolve it completely.
It is not recommended to use rich-foam washing powder.
3. Usage of the detergent
If you select save program, it is suggested to use liquid
detergent instead of washing powder to guarantee the
washing effect.
Please add suitable washing powder as per the laundries
quantity, the set water level and water quantity.
It is suggested to add washing powder into the box directly
under fuzzy program and reserve program.
Confirm if there's
special requirement
for the laundries.
Clear the pocket.
Take out the coins ,
sand,hairpins etc.
Fasten the buttons
and zippers.
When the pulsator is
running ,the buttons of
the laundries may cause
noise. For the sake of
discretion ,please put
the laundries with
buttons into other
laundries.
The quantity of the
laundries shall not
exceed the rated
value. The big
laundries like the
jeans shall be put
in loosely.
a. Check if the laundries are applicable for washing with machine.
b. Divide the laundries with unfast color from other laundries.
c. Put those laundries difficult to absorb water into water with hand.
d. For those laundries with heavy soil, please first remove the dirt like mud or dust. For the parts with heavy soil,
please apply detergent in advance, which can make it easier to remove the soil.
e. For those laundries that may get lint ball and those with long fur, turn it over before putting in.
f. Do not put those laundries polluted by chemicals directly into the washing machine.
For those small laundries and those may get twisting or worn, and woolen/fur laundries, please put them into
mesh bag for washing.
1.Preparation before washing
Preparation before washing
1.Connect the water inlet hose
2.Confirm that the washing machine is earthed reliably.Then insert the
power plug into the receptacle.Do not connect the earth terminal to the
gas pipe and tap water pipe.
3.Put down the drain hose.
4.Slanting or uneven ground may result
in unstable working or abnormal noise.
Please make the machine stand horizontally.
Pay attention to followings before washing the laundries
How to use the whitener
Fill water to decided level. Dilute
the whitener with container. Pour
it slowly into the washing tub.
Avoid using whitener on laundries
with color or pattern as they are
prone to lose color.
The whitener shall not touch the
laundries directly.
Refer to the user's manual for the
usage and quantity of the whitener.
For powder whitener, please
dissolve it before use.
Add washing powder into the box directly
as per indicated in left figure.
After adding, close the box.
Control panel seat
Liquid detergent inlet
The usage and dose of the softener as per the specifications of softener.
Before washing put the softener into the filling entrance(can be found on
the balancing ring by rotating the inner tub, as illustrated in the left
drawing, The softener will put into the washer when rinsing.
After the softener is put in, please don't place for a long time otherwise
softener may solidify and cause flowing not smooth.
When the washer in spin process,please don't push "START/ PAUSE "
button for fear that the softener is put in earlier, which affect the effects.
Softener
inlet
SOFTNER
How to use the softner