Haier HWM70-928NZP Washer User Manual


 
16
Before washing, please fold up the laundry as needed, then put the laundry into the inner tub,
flat and neat.
These fabrics are not washable:
1. Fabrics that deform when soaked in water;
2. Fabrics that shrink, discolor or go through other exterior changes when soaked in water;
3. Fabrics that lose original texture when soaked in water;
4. Fabrics that discolor when soaked in water;
5. Fabrics that have pilling or pressed pile when soaked in water;
6. Fabrics that is damageable when soaked in water.
Even there’s no water in the tub, a certain period is required before spin starting.
Separate the laundries that are not colorfast from other laundries in washing.
After the machine starts operation, you can only set the program and procedure during
washing and soaking,
During rinsing ,you can only set the spinning time, and can not make setting in other cases.
For Standard program, the washing machine will execute fuzzy program automatically to detect
the cloth. After defection, it can set the water level automatically.To select other water level, first
push the “Start/Pause” button, then push the “Water Level” button to set the water level.
After switching on the power, the reserve program is set to off mode automatically. If you need
to set the washing procedure to be finished at reserved time, please push the Delay
button to set the reserve wash program. Refer to reserve button in Page 15 for selection.
When the Delay function is activated, the indicator light of the program you have set will be
off. The digitron will display remaining delay time(hour). During reserve procedure, push the
“Delay” button to display the reserve mode.
To change the running program or cancel the reserve setting, you need to switch off the power
and make new selection.
As the top lid opened, the washer will automatically alarm
and stop running, exclusively during draining and water
filling.
After finishing washing ,it’ll alarm
and switch off power automatically.
Upon completion of washing, iron the
laundry with a steam iron.
Hold the steam iron above the laundry and do
not touch the laundry. Reshape the laundry.
Figure 1
When shrinkage occurs Stretch the laundry to
its original size and locate it with pins. Use a
steam iron to dry the laundry completely. Do
not touch the laundry.
Pin
Figure 2
3 Push “Soak” “Wash” “Rinse” “Spin” button to select suitable procedure program
4 Push the “Water Level” button, select suitable water level
5 Push the “Delay” button to select suitable reserve wash program
6 Push the “Start/Pause” button
Close the top lid Finish washing