Filter
Top Products
Installation and adjustment
The largest allowed slope of the
shank base of the machine is 2 .
The slanting or rough ground will
result in unstable running or
stoppage of the machine. Please
adjust it with following methods:
Adjust the adjustable foot:
Install the bottom plate
After you open the package, please lean
the washing machine gently down on soft
items ( like the towel cloth, blanket, etc. ).
Install the bottom plate to the bottom of the
machine with the eight screws by a cross
screwdriver, then lift the machine up gently.
See to the figure:
Adjust the installation position
Please install and adjust the machine according to the requirement of the manual.
It is very important to your security and correct operating the machine.
Push the lint filter downward to
location for lint filter.
1.To twist the adjustable foot, please
first lift up the side of the foot slightly,
loosen the adjustable nut, and twist
the foot.
2.Fasten the nut after adjustment.
Loosen
Fasten
High
Low
adjustable nut
adjustable foot
Install the lint filter
4
Back
Front
Bottom plate
Screw
Soft items