Filter
Top Products
Unpacking Your W asher
Removeall packingmaterials.This includesthe foambaseandall
adhesivetapeholding thewasher accessoriesinside andoutside.
Open thetop lid to removethestyrofoamdrumbrace.Pull to remove.
Note: Save drum brace.Reinstall whenmovingthewasher.
Inspectandremoveany remainsof packing,tapeor printed
materialsbeforeusing the washer.
Leveling Your W asher
Your washer has 4 levelinglegs; which
are locatedon the four bottom
corners. After properly placingyour washer in its final position, you can
level your washer.
Levelinglegs canbeadjustedby turning themcounterclockwiseto raise
your washer or turning themclockwiseto lower your washer.
High
Low
Adjustable foot
Steps for Installation
Selecta suitablelocationfor the washer on a hard evensurfaceaway from direct
sunlight or heatsourcee.g. radiators, baseboardheaters,cookingappliancesetc.
Any floor unevennessshould becorrectedwith thelevelinglegs locatedon the
bottomcorners of thewasher. The washer mustbeplacedat roomtemperature.
You mustnot placewasher where thetemperatureis at below freezing.
Installing the Bottom Panel:
The purpose of the bottom panel installation is to block the
noise and give you quiet performance of the washer during
the operation.
Steps:
1.You must first lay the washer on its back.
2.Locate the panel on to the bottom of the machine.
3.Use a screwdriver to tighten the screws securing the panel to
bottom of the washer.(8 screws are supplied)
4.Once all screws are tight and the panel is secure return the washer to
its standing position.
17