Filter
Top Products
1.
80 - 100 cm
2.
1.
2.
08
BEFORE USE
INLET HOSE
1. Connect the nut on the inlet hose to the connector on
the water valve.
2. Apply inlet hose to a water tab with cold, fresh water.
Note: Use the hose-set supplied with the
appliance. Old hose-sets should not be reused.
DRAIN HOSE
1. Use the drain hose bracket to keep the end of the
drain hose retained and prevent the outflow of
water. Don't extend the length of the drain hose;
if an extended hose is required, please consult a
serviceman.
2. The height of the drainage outlet must be 80-100
cm. Fix the drain hose to the clip at the back of the
washing machine to prevent it from dropping off.
Note: The drain hose should not be submerged in
water and should be securely fixed and leak-free. If the
drain hose is placed on the ground or if the pipe is at
a height of less than 80cm, the washing machine will
continuously drain while being filled (self-siphoning).
CONNECTING TO THE POWER SUPPLY
Before connecting to the power supply, check:
¬
The socket is adequate for the maximum power of the Washer Dryer
(For safety, fuses in the power circuit should be rated for no less than 15A).
¬ The voltage should meet the requirement.
¬ The power outlet should be capable of accepting the Washer Dryer plug.
¬ Connect the machine to an earthed socket outlet.
InStALLAtIon