Filter
Top Products
18
M
AINTENAN
CE
DISPLAY CODES
DISPLAY CODES AND SPECIAL FUNCTIONS
¬ Foam test function: If the washing machine fi nd much foam,the LED lamp of “time to end” will twinkle completely for 15 mins,then
the washing machine will go on washing. of course, you can touch “Start/pause” to cancel this function.But you had better to hold
this function for protecting motor.
¬ Power-off memory function: In case of abrupt power failure or the need to cut off the power during a program cycle, the present
settings will be saved and the preset operation will resume when the power is on again.
¬ To cancel a program
Press the "Start/Pause" button, then switch off the power and the program is automatically cancelled. Turn the program selector
again to choose another program.
ERROR MESSAGE
CAUSES SOLUTIONS
Err1:The start/pause lamp off and the
buzzer beeping
¬ Door is not properly shut. _ Shut the door properly.
Err2:The start/pause lamp twinkles twice
in 4 seconds.
¬ Drainage error, water not
emptied within 4 minutes.
_ Clean the fi lter and check the drain hose for
blockage. If error still exists, please contact the
maintenance personnel.
Err3:The start/pause lamp twinkles 3
times in 4 seconds .
¬ Temperature sensor
not properly connected or
damaged.
_ Contact the maintenance personnel.
Err4:The start/pause lamp twinkles 4
times in 4 seconds .
¬ Heater error (Appears at
the end of a cycle).
_ Reduce load and then start washing again. If
problem still exists, please contact the maintenance
personnel.
Err5:The start/pause lamp twinkles 5
times in 4 seconds .
¬ The drain hose is in water.
_ Make sure the drain hose is not in water.
Err7:The start/pause lamp twinkles 7
times in 4 seconds .
¬ Motor overheat protection
or damage.
_ Contact the maintenance personnel.
Err8:The start/pause lamp twinkles 8
times in 4 seconds .
¬ Water exceeds protective
level.
_ Contact the maintenance personnel.