Haier HM600TX Washer User Manual


 
Connect the plug to a socket provided with efficient earthing.
Or use the spare earthing wire supplied together with the
machine and the earthing terminal located on the left-upper
corner of the back of your machine (Warning: this appliance
must be earthed as a safety measure according to the law).
Make sure that the voltage and frequency available
correspond with the values stated on the data plate located at
the back of the machine and that the electric system is
dimensioned to withstand the maximum current shown on the
data plate. If the socket the machine is connected to does not
correspond with the plug, replace the plug with a suitable one
and avoid using adaptors or shunts since they could cause
overheating and burn out.The spare eathing wire is
absolutely not allowed to be connected to water
pipe,heating pipe or other kinds of pipes.
7
Installation
Electric
connection
Connection
of tap and
Loading
Hose
Connect the inlet hose to a cold water tap with a 3/4 gas
threaded opening, and fit the filter and the rubber gasket
supplied with the washing machine. Check that it is tightly
screwed to the tap (Fig. 3).
If the water piping is new or has not been used for a long time,
before making the connection, let the water run until it is clear
and free from impurities.
This step is necessary to ensure that the incoming water
does not clog and possibly damage the machine.
Fig. 3