Filter
Top Products
English
Loading the Washer
•
• Separate the white from the colored clothing. Separate heavy fabrics from light
fabrics.
• Carefully check all pockets and cuffs for foreign items. They can easily slide
into the tub and cause damage to the tub and/or make disturbing noises during
cycles.
• Always balance the laundry load evenly within the washer tub, so there is no
single heavy areas and all the laundry is evenly distributed.
the water from entering the washer. Clean this at least once a month.
4. Add the detergent.
5. Add the wash load.
6. Press the Start / Pause button.
7.
turning OFF the machine and then restarting to make the new selection.
If the washer is turned ON without any water in the tub, it will start to
spin after a few minutes. The pulsator will not rotate unless the water is
filled to a selected level.
Note:
Do not use the “HEAVY Wash” program for woolen clothing.
Note:
Note:
Note:
There is a filter in the water inlet valve. This prevents foreign particles in
Selecting the Water Level
•
Your selection may depend on your
There are 3 pre-set water levels to chose from: Low, Medium and High
wash load
.
16
1.
Steps for the Wash Process
2. Press “Cycle Select”to select wash program.
Turn the power ON by pressing the “ON” button.
Select the water level.
3.
After the starts, you may change the cylcle or program by wash ng mach
ne
Load each item loosely.
i
i