Haier Haier Washer User Manual


 
20. This appliance must be connected to a proper electrical outlet with the
correct electrical supply.
21. Proper grounding must be ensured to reduce the risk of shock and fire. DO
NOT CUT OR REMOVE THE GROUNDING PLUG. If you do not have a
three-prong electric receptacle outlet in the wall, have a certified electrician
install the proper receptacle. The wall receptacle MUST be properly
grounded.
22. Hydrogen gas may be produced if the water heater has not been used in
more than 2 weeks. This may be explosive under certain circumstances.
If this is the case turn on all the hot faucets and let the hot water run for a
few minutes before using this appliance. This will let the trapped hydrogen
escape. Avoid accidents during this process by refraining from turning
ON any electrical appliances, smoking, lighting a match/lighter, or using
flames.
23. Do not repair or replace any part of the appliance or attempt any servicing
unless specifically recommended in the user-repair instructions, which you
understand and have the skill to carry out.
If for any reason this product requires service, we strongly
recommend that a certified technician perform the service.
24. To reduce the risk of electric shock or fire, do not use extension cords or
adapters to connect the unit to an electrical power source.
SAVE THESE INSTRUCTIONS
HOUEHOLD USE ONLY
English
3
Note:
Tools and Materials Required
You will need to use the following tools when installing your washer:
1. Phillips Screwdriver - For bottom plate
3. Level - To balance washer
1 2 3 4
4. Open End Plyers - To secure ntake hose
i
i
on
2. Tape Measure - Check measurement of washer locat