Filter
Top Products
English
10
TROUBLESHOOTING
Washer does not operate:
• Check if unit is plugged in.
• Check if the electrical wall receptacle is of proper voltage.
• Check if the circuit breaker needs to be reset or if the fuse needs to be
replaced.
• Check if the washer is overloaded: load may need to be re-balanced and
clothes may need to be redistributed.
• Check if the lid is open. You may have to close the lid properly.
• The washer pauses in some cycles. This is normal in delicate of hand-washable
cycle, which has short soak period where your clothes are being soaked for
very short period of time. You will not hear washer operation for a short peri-
od of time. When the soak time is over, it will start automatically.
Problems with water:
• Not enough water coming out: Water faucet may need to be turned on fully.
Water hoses may be tangled up . Straighten up hoses. Check water level
selection, it may need to be readjusted.
• Water temperature is incorrect: Check your water heater temperature. Hot
water needs to be at a temperature at least 120ºF - 140ºF (49ºC - 60ºC).
Check to make sure the inlet hoses are properly connected. (e.g. hot to hot
and cold to cold.)
• Water leaks: This is due to not properly installing drain hose or fill hoses. Your
home drain may be clogged or having constant waster pressure. You may
need to tighten hoses, check the plumbing or call a plumber.
• Water will not drain: This is due to not installing your drain hose properly. You
may need to connect the drain hose properly. Check the position of the drain
hose. In order to drain properly, make sure that top of drain outlet is less then
4 ft. (1.2m) above the floor.