Filter
Top Products
PROBLEM
POSSIBLE CAUSE
WATER LEAKS
●
Make sure hose connections are tight at faucets.
●
Make sure end of drain hose is correctly inserted in and secured to drain facility.
WASHER IS NOISY
●
Make sure washer is level and firm to the floor with rubber foot pads in place and
front jam nuts tight. See your Installation Instructions.
●
A sharp, distinctive sound will be heard at the end of each spin pried as the motor
stops and the spin brake inside the transmission “locks in.” This sound is normal.
●
Heavily unbalanced loads can cause the washer to vibrate excessively during spin,
and may cause it to move from its original position. In extreme cases (usually occurs
when washing a single, heavy item or a small load when water level is set higher than
necessary), the spin basket may strike the outer tub, creating a loud but harmless noise.
To correct, stop the washer by pushing in the Cycle Selector knob, open the lid and
redistribute the load evenly about the wash basket. Close the lid and restart.
I
WASHER PAUSES
●
Washer normally pauses between washing steps ... such as between wash and spin or
IN CYCLE
between spin and rinse.
If you need more
help...call,
toll free: GE Answer Center
@
/ 800.626.2000/consumer information service
CA~
Am
CLEAN~G
USER MAINTENANCE INSTRUCTIONS
The
~b.
The porcelain is self-cleaning. Leave lid
To Store Washer.
Ask service technician to remove
open after washing to allow moisture to evaporate.
water from drain pump and hoses to prevent freezing.
Do not use harsh or gritty cleansers.
Do not store the washer where it will be exposed
The Exterior.
Wipe off any
spills
of washing
to the weather.
compounds. Wipe or dust with damp cloth. Try
For Long Vacations.
Be sure water supply is shut off
not to hit surface with sharp objects.
at faucets and drain all water from hoses if weather
will be below freezing.
21