Filter
Top Products
PROBLEM
WATER
WON’T DRAIN
WATERLEAKS
WASHERIS NOISY
WASHER PAUSES
IN CYCLE
POSSIBLE CAUSE AND REMEDY
e
Makesuredrain hose is notkinked.
~Top of drain outlet shouldbe less than 8 ft. abovefloor.
eMake sure hose connectionsare tight at faucets.
eMake sure end of drain hoseis correctlyinsertedin and securedto drain facility.
~Make sure washer is leveland firmto the floor with rubber foot pads in place and
frontjam nuts tight, See your InstallationInstructions.
oA sharp, distinctivesound will be heard at the end of each spin period as the motor
stops and the spin brake insidethe transmission
“locks in.” This sound is normal.
eHeavily unbalanced loads can cause the washerto vibrateexcessivelyduring spin,
and may cause it to move from its originalposition. In extreme cases (usuallyoccurs
when washing a single, heavy item or a small load when water level is set higher than
necessary), the spin basket may strikethe outer tub, creating a loud but harmless noise.
To correct, open the lid and redistributethe load evenly about the wash basket. Close
the lid and restart.
QWasher normally pauses between washing steps..such as between wash and spin or
between spin and rinse.
If you need more
help...ca1I,toil free:
GE Answer Center@
800.626.2000
consumer inforniationservice
P.
1
. . IS
. .
. . . . .
—.-...————.—.—.
-..—-.—..
--.—”-.-
—. ———-———---. .—.—-.......,
---
--—
..—..—.,-
..-..
_—____________