Filter
Top Products
PROBLEM
GRAYED CLOT~S
(continued)
~LLOWED
CLO~S
BLUE OR GRAY
COLOR
STA~S
SHRIN~GE,
GENERAL
POSSIBLE CAUSE
● Improper soaking with insufficient detergent. Usually a 30-minute soak is sufficient.
However, when using extended soaks for heavily soiled garments, you may need to
use twice the recommended amount of detergent.
● Use of soap in hard water. Switch to a phosphate detergent, or follow six steps at
the bottom of opposite page.
● Washing too long may result in increased soil deposition. Use shorter wash times
for smaller loads.
● Detergent dissolves too slowly. Detergent must be present in the wash solution at
the start of agitation. See Detergent, Other Additives section.
● To restore grayed clothes:
1.
Put clothes in washer. Fill with HOT water. Check
Maufacturer’s
Care Labels
to determine if hot water is suitable for garment.
●
Add a non-precipitating type of water softener such as
Cdgon
brand with
phosphate—use
2%
times as much as you need for normal water softening.
● Do not use detergent or soap.
● Allow clothes to go through complete cycle.
● Repeat, if necessary.
2. If you prefer to use the Soak Setting, see How to Use the Soak Cycle section.
Use the water softener in place of soak agent or prewash detergent and allow
clothes to soak for about 20 minutes.
3. Use Extra Cleaning cycle, see Tips to Help You Select Settings section.
4. Use the Mini-Basket tub. See How to Use the Mini-Basket Tub section.
● Incomplete removal of body soil due to constant use of insufficient detergent.
Check hem of T-shirt or pillow case. If they are white and center is yellow, it contains
body oil. Restore whiteness following procedures in Grayed Clothes, above.
●
Chlorine bleach may yellow some fabrics with resin finishes. Use oxygen bleach
(such as
Clorox
2 brand). Refer to Garment Manufacturer’s Care Instructions. Restore
color using color remover (such as
Rit
or
Tintex
brands), following package directions.
s
Iron or manganese in water may cause overall yellowing or yellow spots.
1. Use extra detergent plus a non-precipitating water softener dissolved in water
before adding clothes. Use non-chlorine bleach.
2. Have a special filter or chemical feeder
instrdled
in your home to remove iron
and manganese from water.
3. Run hot water for a few minutes to clean iron residue buildup in lines; drain
water heater occasionally.
4.
To remove spots:
Spread stained portion over pan of boiling water and
squeeze lemon juice through stain.
To remove overall yellow,
use a
commercially available rust scale remover, following package instructions. If
porcelain damage can occur, do not use in the washer; use a plastic container.
Improper use of fabric softener. Never pour fabric softener directly on clothes;
always dilute before adding to rinse water. See Other Laundry Products section.
To remove
shins:
Dampen stained area and rub with undiluted liquid detergent.
Rewash, using chlorine bleach if safe for fabric.
Some fabrics will shrink whether washed in a washer or by hand; others maybe
safely washed but will shrink in a dryer. Follow Garment Manufacturer’s Care
Instructions exactly. If in doubt, do not machine wash or dry.
(continued next page)
23