Filter
Top Products
How
to operate your clothes washer
WWmG—TO
reduce the risk of fire, electric
shock, or injury to persons,
read the IMPORTANT
SA~TY
INSTRUCTIONS before operating this appliance.
bad
the washer properly
● Add accurately-measured
detergent to empty tub. See
pages
11 through 13.
●
Load clothes loosely.
Dry clothes
level should be no higher than the
top row of circular holes in the wash
tub. Do not put clothes on top of the
agitator or wind them around it.
For best results, mix large items
with small ones. When washing a
single heavy item, such as a shag
rug or bedspread, add one or two
other pieces to balance the load.
Large items should be no more
than one-half of the total load.
Here is a typical
full
load:
2 double sheets 2 long-sleeve
2 pair trousers shirts
2 standard
pillowcases
. To bleach the load, measure
liquid bleach according to directions
on container. After washer has
filled
and agitated for several minutes, add
diluted bleach to the wash water.
How to use powdered bleach,
fabric softeners and other laundry
products is explained on page 15.
●
Close lid.
Washer will fill and
agitate but will not spin with lid
open. This washer has a Safety Lid
Lock. As a safety measure the lid
will be automatically locked during
the spin portion of each cycle. The
lid will automatically unlock about
30 seconds after the end of the spin
cycle. To open lid during spin cycle,
push Cycle Selector IN and wait for
lid lock to release, about 30 seconds,
before opening.
For your personal safety, never
reach into washer while parts are
moving.
Always stop washer to
load, unload, add forgotten items
or additional laundry aids.
w:jte(
level
Q
Set the controls
See the Controls Setting Guide on
@Push Cycle Selector in and
pages 8 and 9.
turn clockwise to your selected
~Select
Washing Temperature.
wash cycle.
Cold rinse will be automatically
~PullCycleSelector
outto
start
provided with all cycles.
the cycle.
~Select
Water Level.
Note: If you have selected the Perm
Press or Regular cycle and wish to
SMALL: Washer is less than 1/3
change cycle setting after washer
full
of clothes.
has started, push
Cycle
Selector in
MEDIUM: Between 1/3 and 2/3 full.
and wait for washer to stop. Then
LARGE: Over 2/3 full of clothes.
reset to the new position. Setting
can be changed at any time during
the
Perm
Pr~ss
or Regular cycle
.-
Self-cleaning lint filter.
The lint
filter needs no attention from you.
Lint collected during washing and
rinsing of clothes is automatically
flushed down the drain.
How to soak in the washer
Set Washing Temperature control.
Add detergent or soak agent. Turn
Cycle Selector to desired cycle.
Start the washer. After washer fills
and begins to agitate, push in the
Cycle Selector to stop washer. Allow
to soak for as long as desired. After
desired soak, turn to the last Spin.
Pull out the Cycle Selector to
complete the cycle.
Delicate cycle
r
PULL
STAR
USH STOP
o
/f~%l&:
!
/. .$’:
ak.
-
0
To get the full benefit of the
Delicate Cycle, always set it at
the beginning of the cycle. During
wash, the Delicate Cycle alternates
between agitation and pauses to
protect delicate clothes.
6
—...
-.——.—