Filter
Top Products
Operating Instructions Safety Instructions
Consumer Support
Troubleshooting Tips
6
About washer features.
Cleaning the Fabric Softener Dispenser (on some models)
The Fabric Softener Dispenser is self cleaning. This dispenser does not require regular cleaning
like standard fabric softener dispensers. Wipe down exterior surfaces of the dispenser
as needed. If cleaning of the internal dispenser components is needed, follow these steps
after the wash cycle is complete:
The Fabric Softener Dispenser (
on some models)
Lift the tab on the fabric softener
dispense top.
Measure out the fabric softener into
the cap and pour the softener into
the dispenser top. The fabric softener
will drain into the receiving cup inside
the dispenser. Use only “Ultra” or
concentrated fabric softeners.
Push down on the tab to close
the dispenser top. Make sure the tab
is pushed down fully and snaps shut.
Select
FABRIC SOFTENER from OPTIONS
on the control panel.
4
3
2
1
OFF
A
UTO
AUTO SOAK
EXTENDED
2
nd
RINSE
S
PIN
SOAK
F
ABRIC SOFTENER
FABRIC SOFTENER
F
ABRIC SOFTENER
Set when adding
+
2nd RINSE & EXTENDED SPIN
+ EXTENDED SPIN
+
2nd RINSE
O
PTIONS
The fabric softener dispenser automatically releases liquid fabric softener at the proper time
d
uring the cycle.
Do not stop the washer during the first spin. This will cause the dispenser to empty
too soon.
Never pour fabric softener directly on clothes. It may stain them.
To use, follow these steps:
Lift the dispenser top tab and turn the top
counterclockwise using the 2 turning tabs
shown. Lift the dispenser out of the
pulsator.
Clean out any buildup from inside the
pulsator with a soft cloth or toothbr
ush.
Ensure the three rectangular holes
in the bottom which allow the fabric
softener to drain are not blocked.
Gently pull the cap away from
the dispenser cup to separate.
W
ipe surfaces with a soft cloth or soak
the parts in a solution of 1 gallon warm
water, 1/4 cup liquid detergent and 1 cup
bleach. Ensure the small hole in the top
surface of the cap and associated tube
are not obstructed.
R
eassemble the dispenser cup and cap
by snapping them together.
Place the dispenser assembly into
the pulsator. Turn the top clockwise using
the 2 turning tabs shown. Push down
on the tab to close the dispenser top
.
Mak
e sur
e the tab is pushed down
fully and snaps shut.
6
5
4
3
2
1
1
2
3
4
Tab
Turning Tabs
T
urning T
abs
1
3
5
6