Filter
Top Products
=BC0;;0C8>==BCAD2C8>=B
)()$'! (
,'##M#4E4ADB40=
>?4=5;0<4C>C4BC5>A60B;40:B
Check all connections for leaks with soapy solution
or equivalent.
Apply a soap solution. The leak test solution must
not contain ammonia, which could cause damage
to the brass fittings.
If leaks are found, close the valve, retighten the
joint and repeat the soap test.
Open Gas
Valve
!)'!$##)$#
#$'")$#$'('.'(
,'##M)>A43D24C74A8B:>5
58A44;42CA820;B7>2:0=3?4AB>=0;8=9DAH
K Do not use an extension cord or an adapter plug
with this appliance.
K The dryer must be electrically grounded in
accordance with local codes and ordinances,
or in the absence of local codes, in accordance
with the NATIONAL ELECTRICAL CODE, ANSI/NFPA
NO. 70.
!)'!'&*'"#)(
$'('.'(
This appliance must be supplied with 120V, 60Hz,
and connected to a properly grounded branch
circuit, protected by a 15- or 20-amp circuit
breaker or time-delay fuse.
If electrical supply provided does not meet
the above specifications, it is recommended that
a licensed electrician install an approved outlet.
,'##MThis dryer is equipped
with a three-prong (grounding) plug for your
protection against shock hazard and should be
plugged directly into a properly grounded three-
prong receptacle. Do not cut or remove the
grounding terminal from this plug.
Ensure proper
ground exists
before use.
If local codes permit, an external ground wire (not
provided), which meets local codes, may be added
by attaching to the green ground screw on the rear
of the dryer, and to an alternate established ground.
=BDA4?A>?4A6A>D=34G8BCB145>A4DB4
Ground
Screw