GE GTUP240 Washer/Dryer User Manual


 
7
GEApplances.com
D
Temperature
Select the water temperature for the wash and rinse cycles. Always follow fabric manufacturer’s care label or instructions
when laundering.
PerfecTemp senses the incoming water temperature and adjusts the fill water to obtain a more precise temperature range
for all wash temperatures. For example, in a COLD wash selection, some warm water may be added to reach a temperature
needed to better dissolve detergents. Often, detergents are not completely dissolved in very cold water, especially in cooler
climates.
During winter months, when the water entering your home is colder, or for locations with very cold water year round, use the
PerfecTemp plus COLD to help dissolve powdered detergents and to improve the cleaning of your clothes.
The TAP COLD feature turns the PerfecTemp feature on your washer off, and uses your household tap water temperature for a
COLD wash. This can provide energy savings by reducing the amount of hot water used in your wash.
E
Load Size
Loosely load clothes no higher than the top row of holes in the washer basket.
AUTO LOAD SENSING- This selection automatically provides the correct amount of water suited to the size and type of load
placed in the unit.
B
FABRIC SOFTENER
Set this option when adding fabric softener to the washer.
F
START
Press START to begin the cycle. With the lid closed pressing START again will PAUSE the cycle and STATUS lights will blink. To
continue the cycle, close the lid and press START again. The water fill will continue with the lid opened, except when AUTO
LOAD SENSING is selected as the load size. (The lid must be closed to continue filling when AUTO LOAD SENSING is selected.)
If the lid is opened during the cycle, the cycle will PAUSE and the STATUS lights will blink. To resume the cycle, close the lid and
press START.
If the machine is paused for more than 24 hours, the cycle will be cancelled. To stop the cycle, turn the Cycle Selector to the
OFF position.
C
STATUS lights
The STATUS lights show the stage the washer is in. When the selector knob is set to a new cycle, the STATUS lights will flash
momentarily, showing the stages the cycle will go through.
STATUS light Illuminates
ON When the fabric softener option has been selected.
WASH When the washer is in the wash portion of the cycle.
RINSE When the washer is in the rinse portion of the cycle.
SPIN When the washer draining and/or spinning.
LID LOCKED
When the washer lid is locked. This feature prevents the lid from being opened while the
washer is in the spin cycle or coasting to a stop.
NOTE: If the STATUS lights are blinking, the operation of the washer has been paused. To resume operation
press the START button (the lid must be closed).