Filter
Top Products
$1-??19.81;;>??19.8E,76<
After reversing door, there will be a mismatch between the outer door and
the inner door.
Make sure that the handle part of the outer door is opposite the hinge,
as shown.
Turn the door over and fasten the outer door to the inner door using
the 6 large tapping screws (#10).
$%")$%" $%#&%! $,76<
;B1%@>571>-/71@
Using a putty knife or any other flat tool, remove the 5 plastic screw caps
located on the dryer where the door will be installed and install them on
the opposite side.
Switch the strike bracket and its cover on the opposite side by removing
the screws; then reinstall both on the opposite side.
$15:?@-88;;>??19.8E
The door is now ready to be installed on the dryer. To ease this step,
the hinge has keyholes that allow a partially fastened screw to be used
as a hook.
Partially fasten a screw to the uppermost screw hole. Hook the door on the
partially fastened screw.
Fasten the hinge by installing the other 4 screws and tightening the partially
fastened screw above.
Partially
Inserted
Screw
Tighten
All
Screws
16
;:?A91>%A<<;>@&>;A.81?4;;@5:3&5<?"<1>-@5:3:?@>A/@5;:?%-21@E:?@>A/@5;:?
<<85-:/1?/;9