Filter
Top Products
Reversing the Door
Tools needed:
■ Standard #2 ■ Tape-tipped
■ Phillips screwdriver ■ putty knife
Open the door and remove the filler plugs opposite the hinges. With the door completely
open, remove the bottom screw from each hinge on the dryer face. Insert these screws
about half way into the TOP holes, for each hinge, on the opposite side (where you
removed the filler plugs). Apply firm pressure to get the screw started in new holes.
Loosen top screw from each hinge on the dryer face half way. With one hand holding the
top of the door and the other hand holding the bottom, remove the door from the dryer
by lifting it UP and OUT.
Rotate the door 180°. Insert it on the opposite side of the opening by moving the door
IN and DOWN until the top hinge and the bottom hinge are resting on the top screws
inserted in step 1.
Remove the remaining screws from the side of the opening from which the door
was removed. With these screws, secure each hinge at the bottom. Tighten the
two top screws of each hinge. Reinsert the plastic plugs on the side from which
the door was removed.
4
3
2
1
Consumer SupportTroubleshooting TipsOperating InstructionsSafety Instructions
About reversing the door.
ge.com
9