Filter
Top Products
Before you call for service.., gecom
Troubleshooting Tips
Save time and manes! Review the charts on the fallowing pages,
or visit ge.com. You mag not need to call for service.
Problem Possible Causes What To Do
Dryer doesn't start Drger is unplugged • Hake sure the drger plug is pushedcompletelg into
the outlet.
Fuse is blown/circuit breaker • Checkthe house fuse/circuit breaker box and replace
istripped fuse or reset breaker.NOTE:Host electric drgers use
two fuses/breakers.
Dryer doesn't heat Fuse isblown/circuit breaker is • Checkthe house fuse/circuit breaker box and replace
tripped; the drger mag tumble both fusesor reset both breakers. Yourdryer may tumble
but not heat ifonlg one fuse isblown or one breaker is tripped.
Gasservice is off • Hake sure gas shutoff at drger and main shutoff are
fullg open.
No heat temperature • Selectanother heat setting.
selected
Dryer shakes or Someshaking/noise is normal. • Hove drger to an even floor space,or adjust leveling legs
makes noise Drger mag be sitting unevenlg asnecessarg until even.
Greasy spots on clothes Improper use of fabric softener • Followdirections on fabric softener package.
Drging dirtg items • Usegour drger to drg onlg clean items. Dirtg items can
with clean ones stain clean items and the drger.
Clothes were not • Sometimesstains which cannot be seenwhen the clothes
completelg clean arewet appear after drging. Useproperwashing procedures
beforedrging.
Lint on clothes Lint filter is full • Cleanlint screen before each load.
Improper sorting • Sortlint producers (likechenille)from lint collectors
(likecordurog).
Static electricitg can attract lint • Seesuggestions in this section under STATIC.
Overloading • Separatelarge loads into smaller ones.
Paper,tissue, etc., left in pockets • Emptg all pockets before laundering clothes.
Static occurs No fabric softener was used • Trg a fabric softener.
• Bounce®FabricConditioner DrgerSheetshave been
approved for usein all GEDrgers when used in accordance
with the manufacturer's instructions.
Overdrging • Trga fabric softener.
• Adjust setting to LESSDRYor DAMPDRE
Sgnthetics, permanent press • Trg a fabric softener.
and blends can cause static
Inconsistent Tgpe of heat • Automatic drging times will varg according to the tgpe
drying times of heat used(electric,natural or LPgas),sizeof load,
tgpes of fabrics,wetness of clothes and condition of
exhaustducts.
!]