Filter
Top Products
13
REMOVE DOOR ASSEMBLY
(cont.)
Lay the door down on a soft protected flat
surface so that the inner part faces upward
(door resting on the handle side).
Remove the 6 large tapping screws
(#10) located around the perimeter of the
door outlining the gasket, the 4 machine
screws (#8).
With the screws removed, turn the door over
and separate the silver cover part of the door
from the door frame and set aside.
2
6 #10 Large
Screws
2 #8 Machine
Screws
2 #8 Machine
Screws
REMOVE HINGE
IMPORTANT: Note the location of the hinge
(left or right) before removing.
With the door frame part of the door laid
down on a protected soft surface, remove
the hinge cover by removing the 2 tapping
screws (#8) that fasten it to the frame. The
hinge cover is located at the opposite side
of the hinge assembly.
Remove the window retainer and set it aside.
The window retainer is located on the side
opposite the hinge assembly and underneath
the plastic cover.
Remove the hinge
assembly by removing
the 2 machine screws
(#8) that fasten it to the
frame. Pull the hinge
assembly out of its
cavity and set it aside.
3