Filter
Top Products
Tools Needed:
● Standard # 2 Phillips screwdriver
● Tape-tipped pu~ knife
● Needle-nosed pliers
12
1 Open the door and remove the
filler plugs opposite the hinges.
2 With the door completely open,
remove the bottom screw from
each hinge on the dryer face.
3 Insert these screws about half
way into the TOP holes, for
each hinge, on the opposite side.
(Where you removed tie filler
plugs.) Apply firm pressure to
get the screw started in untapped
holes.
4 Loosen the top screw from each
hinge on the dryer face halfway.
5 With one hand holding the top
of the door and the other hand
holding the bottom, remove the
door from the dryer by lifting it
UP and OLTT.
6
7
8
9
Rotate the door 180°. Insert it
on the opposite side of the open-
ing by moving the door IN and
DOW until the top hinge and
the bottom hinge are resting on
the top screws inserted in step 3.
Remove the remaining screws
from tie side of the opening
from which the door was
removed. With these screws
secure each hinge at the bottom.
Tighten the two top screwsof
each hinge.
Reinsert the plastic plugs on
the side from which the door
was removed.