Filter
Top Products
19
Reversing the Dryer Door Swing
Open the dryer door. Remove the 4 hinge hole
plugs or screws from the left side of door
opening. Place nearby for future installation.
NOTE:
You may need a plastic knife to help pull
out the plugs. Be careful not to scratch the paint.
Remove the four screws that secure the door
hinges to the dryer front panel.
NOTE:
Remove
1 screw from each of the 2 hinges first. Hold the
door firmly before removing the last 2 screws.
Rotate the door 180° and reinstall the door
hinges to the dryer front panel with the 4 screws.
Install the 4 hinge hole plugs or screws that were
removed in step 1 into the open screw holes on
the right side of the door opening.
4
3
2
1
Replacement Parts
If replacement parts are needed for your dryer, visit
GEAppliances.com
, or call
GE Parts and Accessories
at 800.626.2002 or contact an authorized parts
supplier.
WARNING:
Destroy the carton and plastic bags
after the dryer is unpacked. Children might
use them for play. Cartons covered with rugs,
bedspreads or plastic sheets can become
airtight chambers causing suffocation.
Place all materials in a garbage container or
make materials inaccessible to children.
WARNING:
The instructions in the manual and
all other literature included with this dryer are
not meant to cover every possible condition
and situation that may occur. Good safe
practice and caution
MUST
be applied when
installing, operating and maintaining any
appliance.
Remove 4 screws—one from each hinge first
Consumer SupportTroubleshooting Tips
Operating Instructions
Safety Instructions Installation Instructions