Filter
Top Products
5
1. Remove iron from power base. Using
a cup, slowly
pour 6 ounces
(
3
⁄4 cup) of tap
water into water
tank opening.
Do not fill iron
directly from
the faucet.
2. Plug power base into outlet.
3. Turn
the Temperature
Control Dial
to desired fabric setting in the steam
range.
4. Allow three minutes for the iron to
reach desired temperature.
5. Set Adjustable Steam Switch to the
recommended
steam level.
See “Fabric
Setting Chart”
on page 4.
To Steam Iron
NOTE: Do not attempt to fill iron while in power base.
Opening
6. To turn iron off, set Adjustable Steam
Switch to O (Dry Iron). Turn the
Temperature Control Dial to Off and
unplug iron from base.
7. Empty water from the iron following
directions in “Caring for Your Iron.”
NOTES
• When first steaming from an empty
iron, up to 20 seconds may be needed
before the iron begins to steam.
• For best results, always return the iron
to the power base when not in use,
even if only for a few seconds.
Water
For best steam performance, use ordi-
nary tap water. If you have extremely
hard water, alternate between tap water
and distilled water for use in the iron.
To Dry Iron
3. Turn Temperature Control Dial
to desired
temperature.
Allow three
minutes for iron
to reach desired
temperature.
4. To turn iron Off, turn Temperature
Control Dial to Off and unplug
power base.
1. Plug power base into outlet.
2. Set the Adjustable Steam Switch
to O (the Dry
Iron position).
Using Your Iron
840096400 Ev02 6/18/02 10:18 AM Page 5