Filter
Top Products
Spray and Blast of Steam Buttons – Push
Blast Button for an
extra blast of steam.
Push Spray Button
to release a fine
spray
of water for
difficult
wrinkles in
cotton or linen.
Reheating Light – This light comes on
when the iron is
drawing power from
the base. The iron
may be used even
when this light is on,
but for best results,
wait for this light to
go off before remov-
ing iron from base.
Power/Reset Light Button – Light comes
on when the base is
plugged in and
remains on for
approximately one
hour. After one
hour, the light goes
off and the iron will
turn off. Push the
button to turn the
power base back on
for another hour of ironing.
Adjustable Steam Switch – This switch
provides
minimum
steam for wool or
maximum steam
for linen. Set the
switch to O to
change to
Dry Iron.
Power/
Reset
Light
Button
4
Features
Blast Spray
Fabric Setting Chart
Ironing Instructions
Dry iron using spray if necessary.
Dry iron on the wrong side of the fabric.
Use a press cloth and steam iron on the
wrong side of fabric.
Iron while fabric is still damp.
Iron using spray if necessary.
For cotton, iron while still damp or use
spray. For linen, iron fabric on wrong side.
Temperature Setting
Off
Nylon, Acrylic
Silk
Wool
Polyester
Rayon
Cotton, Linen
Dry Iron
Steam Range
Steam Setting
Re-heat Light – This light comes on when
the base is first
plugged in and will
go off after the
iron is ready to use.
If this light flashes
during use, return
the iron to the base
until the light goes
off again. When
this light begins to flash, it will automati-
cally shut off the steam function.
NOTE: A popping sound in the iron when
the Reheat Light goes on or off is the
anti-drip system. This is normal.
Reheating
Light
Re-heat
Light
O
840096400 Ev02 6/18/02 10:18 AM Page 4