GE 14-A037 Washer/Dryer User Manual


 
• Top caps on the washer
and dryer must be
removed and replaced
with a top sheet kit. The
addition of a standard
1-1/2" thick countertop
over the pair will result
Washer
Top Sheet
Dryer
Top Sheet
Countertop
A
B
C
3/4" High x 3/4" Wide
Lip on All Sides
DIMENSION A:
14" recommended,
however this laundry pair
can be elevated to suit
customer needs.
• All four sides of the plat-
form should be perman-
ently secured and
extend a minimum of
3/4" above the platform.
• Height is only limited by
the use of overhead
cabinetry.
• The standpipe height
must be increased to
accommodate additional
installation height.
DIMENSION B:
• The platform must be
constructed to include a
3/4" high and 3/4" wide
lip all the way around
the top edge. The outside
depth should be 29"
minimum. Consideration
should be given to the
location of the washer
standpipe and dryer
duct run.
DIMENSION C:
• The outside width
should be wide enough
to accommodate the
laundry pair, plus a 3/4"
lip on each side.
Recommend 56" to
60" width.
• The platform surface
must be constructed to
minimum code floor
requirements.
• The structure must be
secured to a rear wall.
• To complete the
installation follow
instructions packed with
the washer and dryer.
• Order Built-In Instruc-
tions, Pub. No. 14-T029
• No trim kits required.
in a standard 36"
countertop height.
• Install the washer and
dryer according to the
installation instructions
packed with the
products.
Built-In
Under Counter
Create an efficient work space for folding and storage.
• Install an extra deep
countertop to accom-
modate the laundry pair.
Adjacent cabinets can be
moved forward to align
with the front face of the
washer and dryer.
• Order Accessory Kits:
Washer Pub. No. 14-A037
Dryer Pub. No. 14-A008
Elevate the pair for easy accessibility and a custom appearance.
I n s t a l l a t i o n O p t i o n s