Furuno DWF-200M Washer User Manual


 
15
PROBLEM CHECK POINT
These cases are not malfunctions
The sound "wing" heard during water supply is the operating sound made by the water
inlet valve.
The sound "sha" heard in stopping the tub is the sound that comes from the
autobalancer of the tub.
The sound "wung" heard during wash or spin is the operating sound made by the air
bubble generator.
TROUBLE SHOOTING
The washer will not spin;
If the clothes is collected on one side
during spin and the tub becomes
unbalanced, the spin operation will be
interrupted, and then this unbalanced
condition will be corrected by following
operation: WATER SUPPLY RINSE
DRAIN However if the unbalanced
condition is unchanged despite repeating
the above operation, the lamp will
light up, and the buzzer will sound to
indicate a problem.
Most problems are easily solved if you understand the cause.
Check the following list for problem befor calling for service.
Before calling for service, check these
The washer will not
operate at all.
Water is not supplied;
If water supply is not finished within 20
minutes, the lamp will light up, and
the buzzer will sound to indicate a problem.
The washer will not drain;
If the drain is not finished within selected
time, lamp will light up, and the buzzer
will sound to indicate a problem.
Is there a power failure?
Is the power cord correctly connected to an electric outlet?
Is the electric fuse broken?
Did you turn on the power?
Did you press Start/Hold button?
Is there correct amount of water in the tub?
Did you connect the inlet hose and open the water tap?
Is the inlet hose or the water tap frozen?
Is the water supply shut off?
Does foreign matter block up the inlet hose filter?
Is the drain hose frozen or blocked up by dirt?
Is the drain hose kinked or deformed?
Is the end of the drain hose immersed in water?
Is there excessive dirt inside the pump housing?
Is the clothe in the tub collected on one side?
Is the washing machine installed on an uneven floor or is the
vibration serious?
Is the lid open?
(The lamp will light up in this case.)
NOTE
Please check the point before calling for a service.
If the supply cord is damaged, it must only be replaced by a repair shop appointed by
manufacturer, because special purpose tools are required.
DWF-200/240M(101) 97.1.19 4:22 PM ˘`15