Frigidaire GLEQ2170KE Clothes Dryer User Manual


 
6
Common Drying Problems
Many drying problems involve poor cleaning results, poor soil and stain removal, residues of lint and scum, and fabric damage.
For satisfactory drying results, follow these suggestions provided by The Soap and Detergent Association.
PROBLEM POSSIBLE CAUSES SOLUTIONS PREVENTIVE MEASURES
Greasy, oily
stains
Fabric softener sheet.• Rub fabric softener stains with bar •
soap. Rinse and rewash.
Add a few bath towels to small loads for •
proper tumbling.
Some “silk-like” fabrics should be air •
dried.
Use proper drying temperature.•
Place fabric softener sheet on top of load •
before starting the dryer.
Lint Overloading.•
Overdrying causes static •
electricity.
Lint screen not clean when •
cycle began.
Lint is attached to “pills.”•
Reduce load size and rewash using •
liquid fabric softener in the final
rinse.
Or, add a fabric softener sheet and •
tumble without heat.
Use lint brush or roller to remove •
lint.
Do not overload dryer.•
Use fabric softener in washer or dryer to •
reduce static electricity.
Remove items when they are slightly damp •
to avoid overdrying.
Check that lint filter is clean and in place.•
Pilling
(Fibers break off,
ball up and cling
to fabric.)
Overdrying.• Use a lint brush or shaver to re-•
move pills.
Use fabric softener to lubricate fibers. •
When ironing, use spray starch or fabric •
finish on collars and cuffs.
Turn items inside out to reduce abrasion.•
Shrinking Temperature too high.•
Overdrying.•
Irreversible condition.• Follow fabric care label directions.•
If shrinking is a concern, check load often.•
Remove items while slightly damp and •
hang or lay flat to complete drying.
Block knits into shape.•
Wrinkling Overloading.•
Leaving items in dryer after •
cycle ends.
Reduce load size and tumble at •
medium or low heat for 5-10
minutes.
Remove items immediately. Hang •
or fold.
Do not overload dryer.•
Remove items as soon as cycle ends.•
Do not store or place laundry
products on top of dryer at any time. They can
damage the finish or controls.
Care and Cleaning, con’t
OUTSIDE
Clean the cabinet with mild soap and water. Never use harsh, gritty or •
abrasive cleansers.
If the cabinet becomes stained, clean with diluted chlorine bleach (1 part •
bleach to 8 parts water). Rinse several times with clear water.
Remove glue residue from tape or labels with a mixture of warm water and •
mild detergent. Or, touch residue with the sticky side of the tape or label.
When cleaning chrome parts use a window cleaner with ammonia or mild •
soap and water.
Before moving the dryer, place a strip of cardboard or thin fiberboard un-•
der the front leveling legs to prevent damage to the floor.