Filter
Top Products
28
WASH CYCLE OPTIONS
Add a Garment (WH7060P and WH8060P models only)
The ‘Add a Garment’ option enables you to add or remove items during the wash stage
of the cycle, under certain conditions. Once the ‘Add a Garment’ button is touched, the
button and time to go will flash. Wait until you hear the door unlock. Open the door
and add or remove items. Close the door and touch to restart the cycle. The ‘Add
a Garment’ button will only operate during the wash part of the cycle and when the
temperature selected is lower than 60°C. ‘Add a Garment’ can be used when the total
wash volume has been reached, as your washer will drain the water to a lower level if
necessary, so the door can be opened.
Keylock
This option enables you to deactivate the buttons on the display panel, except for the
‘Power’ and ‘Keylock’ buttons. This prevents accidental button presses.
To turn Keylock mode ON or OFF when the washer is powered on:
Touch and hold the button for 2 seconds.
Note: when activated, the light above the button is illuminated.
If Keylock mode is activated and the machine is powered off:
To turn your washer on, press the button, then touch and hold the button for
twoseconds. Select your wash cycle, options and then touch to start the cycle.
To turn the washer off at anytime when keylock is activated simply press the button.
Delay Start
The ‘Delay Start’ option enables you to delay the start of the wash cycle from between
5minutes and 12hours. Times you can select are 5min, 15min, 30min, 1hour, then
hourly up to 12hours. This can be useful to time your washing to finish when you arrive
home from work, or to start once you have finished in the shower. Some stain removers
also require you to spray them on then leave for several minutes, before washing.
Your washer will wait for the selected time then start without you having to wait or
remember to start your machine.
To programme a ‘Delay Start’ time, simply touch the ‘More’ button to increase the
delay time and ‘Less’ button to decrease the time or turn ‘Delay Start’ off. Touch
to confirm your selection and start the countdown. Once started, the time will count
down on the digital display screen in 1 minute increments, the ‘Delay Start’ light will
flash and the light will stop flashing and turn on solid.
Note: if you hold the ‘More’ button down, the time displayed on the screen will increase
after every half a second (more convenient than touching the button repetitively).
To remove a ‘Delay Start’ time once it is counting down, simply touch , then touch the
‘Less’ button to decrease the time to zero. Touch to start the cycle immediately.
Note: we suggest that you avoid using ‘Delay Start’ for damp, non-colourfast items as
this may cause dye run to occur. We also recommend you use powder detergent when
you use the ‘Delay Start’ function.