Filter
Top Products
29
Machine Information
When You Have Finished
Turn off the taps to prevent the chance of flooding should
a hose burst.
Turn off the power at the wall.
Cold Water Washing
If you always use cold water, we recommend that a warm
or hot wash be used at regular intervals, eg every 5th wash
should be at least a warm one.
Cleaning Your Smart Drive®
Clean with a soft damp cloth and wipe dry. Do not use
scouring cleaners as they can damage the paint, plastic
and panel surfaces.
Clean the fabric softener dispenser after each cycle using
warm soapy water.
You can remove the lid for cleaning. Open the lid fully, hold
one side with one hand and gently tap the other side with
an upward motion.
To replace the lid, hold the lid vertically and align both
hinges before pushing down firmly.
To remove the agitator for cleaning, unscrew the nut down
the centre of the agitator by turning anti-clockwise.
The agitator must be fully pushed on to the shaft when refitting. Tighten the nut firmly by
hand. Ensure the agitator is not loose.
Cleaning the Inside of Your Smart Drive®
If you use fabric softener or do regular cold water washing, it is important that you occasionally
clean the inside of your machine.
Fill your machine with hot water. Add about two cups of a powdered detergent that contains
phosphate.
Let it agitate for 10-15 minutes.
Stop the machine, open the lid, and leave it to soak overnight.
After soaking, drain the machine and run the machine through a regular cycle.
We do not recommend that you wash clothes during this procedure.