Fisher & Paykel MW512 Washer User Manual


 
27
Changing Pre-set Options
Controlled Cold
Model Only
If your cold water temperature is very low you will not get a very effective wash. The controlled
cold option solves this problem by adding a small amount of hot water to raise the temperature
of the wash. We have called this ‘Controlled Cold’.
1
Select COLD wash temperature.
2
The Wash Progress lights show the temperature adjustment possible.
When the first progress light is on, the machine will fill with cold water only.
Press ADVANCE to select the second light and your Smart Drive® will control the temperature to
approximately 20˚C. Each following light equals approximately a 1˚C temperature rise.
Note:
If you always use cold or controlled cold water, we recommend that a warm or hot wash be
used regularly, eg. every 5th wash should be at least a warm one.
End of Cycle Beeps
Model Only
The beeps signalling the end of the cycle can be increased or decreased. Press the options
button up to increase beeps or down for no beeps.
Water Saver
Model Only
You can increase or decrease the volume of water added during the rinse on the Water Saver option.
Auto Water Fill Level
Model Only
If you are not satisfied with the level that your
Smart Drive® fills to on Auto Water Level, you
can increase or decrease the fill level that Auto
will select.
Note:
If you feel there is not enough water for the
load, we recommend you check by pausing
the machine and pushing the clothes down to
see how much spare water is at the bottom of
the bowl. Clothes often float and your Smart
Drive® can sense the water under the clothes.
Light on Option
FAVOURITE
less water
PERM. PRESS
factory setting
WOOL
more water +
DELICATE
more water ++
HEAVY DUTY
more water +++