Filter
Top Products
19
EN
All About The Options Button
Your Intuitive has a ‘menu’ of wash options that you can use. The buttons and the display screen
on the right hand side of the panel are used to select and display the different wash options.
To Select a Wash Option
1.
Push either the Options UP or Options DOWN arrow.
The Options Menu will then be displayed.
2.
Scroll through the options by using either the UP or DOWN
arrows. To select an option use the ADJUST button. The
option will be highlighted to show you have selected it.
3.
Press HOME, the display will return to the home screen where
your selected wash option(s) will be displayed.
4.
To start the machine push START/PAUSE.
Note: If you want to change any of the wash options while your machine is running you will
need to press START/PAUSE before changing an option.
To Customise a Wash Option
You can program your Intuitive washer to remember the wash
options you prefer. For instance, you may want to set your
washer to always select a warmer wash temperature.
1.
Push either the Options UP or Options DOWN arrow.
The Options Menu will then be displayed.
2.
Scroll through the options until the one you want is displayed.
3.
Select the setting before the option you are wanting to
change. Hold down the ADJUST button for 3 seconds. You
will hear a long beep and SETTING SAVED will appear
briefly on the screen. Your preferred wash options will be
automatically selected every time you turn your machine on
and will be displayed on the home screen.
4.
To change your customised options repeat these above steps.
Note: Water levels, Eco (Save Water++) and Delay Start are not able to be customised.
Time To Go
Your Intuitive washer will display what stage of the cycle the machine is at and how many
minutes the wash cycle has to go, so you can tell at a glance when your washing will be finished.
The ‘Time to Go’ is displayed from the beginning of the agitation wash, as the load size and
fabric type have to be determined before the cycle time can be calculated.
A series of symbols are also displayed on the screen to indicate what point the cycle is up to
(refer to page 15).