Filter
Top Products
28
Changing Pre-set Options
Out-of-Balance Recovery Routine
When your Smart Drive® is spinning it can sense if the
wash load is out-of-balance and will stop and re-try
spinning up to 3 times. If it still senses an unbalanced
load there are two options the machine can take.
Automatic Recovery Option
Your Smart Drive® will try to automatically correct the
out-of-balance load. It will fill with water and agitate to
redistribute the load before trying to spin up again.
Machine Stops Option
Your Smart Drive® will stop, give a short burst of beeps
every 5 seconds, and the RINSE or SPIN light will flash.
You must redistribute the load more evenly yourself.
(Use this option if you wish to conserve water).
Machine Information
Specifications
Electrical Supply: 220–240V, 50Hz Sinusoidal, 165W
Inlet Water Pressure: Max. 1MPa (150 psi) Min. 34Pa (5 psi)
Inlet Water Flow Rate: Min. 3litres/min
Standpipe Height: 850–1200mm
Note:
Exact height of your Smart Drive® is dependent on how far the feet are inserted onto the base
of the machine.
*Height is measured to the highest point on the console.
Model Capacity Depth Width Height* Height (Lid Open)
GW712 7.5kg 650mm 650mm 1020–1050mm 1410–1440mm
GW612 6.5kg 600mm 600mm 1020–1050mm 1360–1390mm
GW512 5.5kg 560mm 560mm 1020–1050mm 1320–1350mm
MW612 6.5kg 600mm 600mm 1020 – 1050mm 1360 – 1390mm
MW512 5.5kg 560mm 560mm 1020–1050mm 1320–1350mm
REGULAR
light on = automatic recovery
REGULAR
light off =machine stops