Filter
Top Products
2120
Pressing POWER does not turn
the machine on.
Pressing START / PAUSE does
not start the fill.
Filling continuously.
Not spinning properly.
Spin speed sounds slower than
it should.
Machine is continually going out
of balance.
Too much or too little water
when filling on Auto water level.
Noises.
Small puddle of water coming
from under the machine.
1. Is the power switched on?
2. Unplug machine from the wall.Wait 60 seconds, plug
back in and operate the machine.
3. Could your household power supply be at fault?
Tr y plugging in another electrical appliance.
1. Are both hot and cold faucets turned on?
2. Are the inlet hose screens blocked?
3. Is DELAY START on?
1. Check that the machine is not siphoning.
2. Check the black hose guide is installed.
1. Is the load out of balance? (refer pages 11 and 16).
2. Check the machine is level and does not rock.
3. It may have suds build-up (refer spin light flashing,
page 22).
1. The clothes are unevenly distributed in the wash
basket, your Ecosmart has compensated by
lowering the spin speed.
1. Check the machine is level and does not rock, and has
rubber feet fitted.
2. Too much water for load (page 8).
1. It may still be in the process of sensing the water level.
(Refer to page 8).
2. Some loads do not suit Auto water level eg pillows,
bedding, large bulky items. Manually select the
water level.
3. Refer to pages 14 to 16 to adjust the Auto fill level.
1. Banging - load is out of balance (refer page 11).
2. Other noises - refer page 19.
1. The water level is too high for the amount of clothes.
This has caused excessive splashing. Use a lower
water level.
2. Large bulky garments (eg pillows, comforters) can
cause splashing. (Wash on Delicate cycle.)
OPERATING PROBLEMS
SYMPTOMS POSSIBLE SOLUTIONS
If the problem persists refer to back cover for service contacts.
PROBLEM SOLVING
(BEFORE CALLING FOR HELP PLEASE LOCATE THE SERIAL
NUMBER OF YOUR WASHER ON ITS BACK LEFT CORNER).
420294 US Ecosmart.qk 11/8/03 10:14 AM Page 22