Filter
Top Products
14
4.
6.
5.
Tilt
Walk
Slide out
4. Remove the carton
by lifting it off the
product (do not cut
the carton off).
5. Remove the basepacker
by tilting the product
back and walking the
product off it.
6. Remove the drum
packer being careful to
rescue the cable clamp
from it. Remove the tape
from the lint collector
bucket.
off
2.
1.
3.
1. Remove straps. 2. Unfold the bottom flaps
on the carton.
3. Unfold the top flaps on
the carton, remove top
packer.
Installation
Unpacking
■
Only remove the packaging at the customer’s premises.
■
This will ensure the appliance arrives in pristine condition and reduces the risk of transport damage.
■
Make sure the dryer is in a suitable location for installation.
■
Consider installing the dryer before the washing machine in a side by side installation, this will
allow better access to electrical and exhaust connections.
Remove Packaging
Level Machine
■
Check the dryer is level, and make necessary adjustments to the front levelling feet.
■
The rear levelling feet are self adjusting.
Final Installation Check List
Check that:
■
All joints in the ducting are made with duct tape – no screws are used.
■
Ducting is clean and is connected to the dryer.
■
Dryer is level side to side and front to back
■
Customer has been shown how to use the dryer.
Note:
This dryer has a drum reversal feature to reduce clothes tangle. Throughout the drying cycle the
motor will run for four minutes, then stop and run in the opposite direction for forty seconds
before reversing again.