Filter
Top Products
CHANGING PRE-SET OPTIONS
When your ecosmart is spinning it can sense if the
wash load is out of balance and will stop and retry
spinning up to 3 times. If the machine still senses an
unbalanced load there are two options the machine
can take.
• Automatic Recovery Option:
Your ecosmart will try to automatically correct
the out of balance load. It will fill with water and
agitate to redistribute the load before trying to
spin up again.
• Machine Stops Option:
Your ecosmart will stop, giving a short burst of
beeps every five seconds and the RINSE or SPIN
light will flash.You must redistribute the load more
evenly yourself. (Use this option if you wish to
conserve water.)
1. Enter the Option Adjustment Mode.
2. Use the HEAVY DUTY button to select the Out
of Balance recovery option you prefer.
3. Press Power to store your selection.
If you are not satisfied with the level that your
ecosmart fills to on AUTO WATER LEVEL, you can
increase or decrease the fill level that Auto will
select.
Note: If you feel there is not enough water for the
load, we recommend you check by pausing the
machine and pushing the clothes down to see how
much spare water is at the bottom of the wash
basket. Clothes often float and your ecosmart can
sense the water under the clothes.
1. Enter the Option Adjustment Mode.
2. Use the CYCLE buttons to increase or decrease
the amount of water selected.
3. Press POWER to store your selection.
OUT OF BALANCE
RECOVERY ROUTINE
AUTO WATER FILL
LEVEL
16
OUT OF BALANCE
RECOVERY OPTIONS
HEAVY DUTY
light on = automatic recovery
HEAVY DUTY
light off = machine stops
AUTO WATER LEVEL
ADJUSTMENT
Light on
FAVORITE = less water
PERM. PRESS = less water
WOOL = factory
setting
DELICATE = more water
REGULAR = more water
*2228 F&P Ecowasher Bk 11/6/01 1:24 PM Page 16