Filter
Top Products
CONNECTING
DRAINAGE SYSTEM
9
CONNECTING WATER AND
DRAINAGE SYSTEM
The water inlet tube is located inside the
drum:
a Connect the elbow end of the tube to
the threaded intake of the electro valve
located at the back of the machine.
b Connect the other end of the tube to
the water intake. Once you have
completed this operation, tighten the
connecting bolt firmly.
installation and setup
The elbow part of the drain tube must
be firmly connected to the outlet, so it
does not fall off, in order to avoid the
risk of flooding.
If your washing machine has an inlet for
hot water, connect the red threaded
tube to the hot water faucet, and to the
electro valve with a red filter.
The washing machine must be
connected to the water inlet system
using the new inlet tubes provided with
the machine. The previously used water
inlet tubes must not be used.
For the washing machine to function
properly, the water pressure should be
0.05-1MPa (0.5-10 kg/cm
2
/ 1.10-22.05
psi).
a It is recommended to have a fixed drain
outlet, 50-70cm/19.69-27.56in from the
floor.
The supplied elbow should be used to
prevent the drain tube from being too
tight, bent or pinched.
2
Important!
max.
70 cm.
27,56”
min.
50 cm.
19,69”
CONNECTING
WATER SYSTEM