Filter
Top Products
5
ENGLISH
INSTALLATION INSTRUCTIONS
Read these instructions carefully and completely before you install the machine. The installation should be
carried out by a qualified person who is familiar with all local codes and ordinances for electrical and
plumbing connections. Incorrect installation may cause damage and/or injury. If the integrity of the machine
is in doubt, do not use it. Call your dealer for qualified assistance.
The machine can be installed anywhere provided that the temperature is not less than 38° F (3° C) and the
electrical cords and hoses behind the machine are not cramped.
To install the machine, follow the steps below:
1. Move the machine to its installation position and remove the outer
wrapping and the polystyrene base.
2. For transport reasons, the drum is locked in position. Loosen the
four locking bolts and remove them along with the plastic spacers
(Fig. 1).
NOTE: If the plastic spacers cannot be removed from the machine,
open the side panel by loosening the screws indicated as “V” in
Fig. 1. Remove the spacers and replace the panel.
3. Next, loosen the two locking screws (Z) and remove the two pins
(U), as illustrated in Fig. 2. Keep the bolts, screws and pins for
future use.
4. Plug the holes with the six plastic plugs packed inside the drum
with the documentation (Fig. 3).
5. Level the machine by adjusting the feet by screwing or unscrewing
as needed. Once the machine is level, tighten the locknuts (Fig. 4).
V
FIG. 1
FIG. 2
Z
U
FIG. 3
FIG. 4