Filter
Top Products
10
THE CONTROL PANEL
The control panel on your Eurotech tumble dryer is easy to understand and simple to operate. Simply turn
the control knob clockwise to the desired setting, select the program temperature (delicate or normal), and
press the ON/OFF button.
ON/OFF BUTTON AND LIGHT
Press this button to turn the power to the machine on and off. When the power is turned on, the ON/OFF
light will flash briefly and a tone will sound. At the end of a program, an end-of-program tone will sound and
this light will flash until the door is opened.
If the On/Off light flashes at the start of a program, the Program knob was not turned to the stop position
(see below) at the end of the previous program. Turn the Program knob to the stop position and wait for a
tone. You can then set the knob to the new program.
DELICATE/NORMAL BUTTON AND LIGHT
This button lets you select between a normal and low drying temperature.
NOTE: Always refer to the care label on the garment to determine if it can be tumble dried. (See page 9.)
Normal: The Normal temperature setting is for sturdy fabrics, such as cotton, linen, and denim. If this
button is not pressed in, the temperature setting is Normal. The light will stay lit to indicate the
Normal setting is selected.
Delicate: The Delicate temperature setting is for synthetics, such as cotton/polyester blend, rayon, ac-
etate, washable silk or nylon. If this button is pressed in, the temperature setting is Delicate. The
light will flash to indicate the dryer is set on Delicate .
DRAIN BUTTON AND LIGHT
If the condensed water tank is full, the Drain light will flash and the dryer will stop. To resume the program,
empty the tank and press the drain button for about ten seconds to allow the drain pump to pump the water
in the sump area back into the water tank. When the Drain light stops flashing, reset the Program knob to
the desired setting to restart the dryer.
PROGRAM KNOB
Turn the Program knob clockwise (right) to the desired setting. The programs on the right of the dial are for
cottons and linens. The programs on the bottom are for synthetics. You can also set a timed dry program for
60, 40 or 20 minutes (on top left of dial).
Stop Position – The stop position is where the line on the knob aligns with the dot at the top of the dial. To
shut the dryer off, continue to turn the knob clockwise to the stop position.
NOTE: The dryer will not start unless the door is closed securely and there are no items caught between
the door and the opening.
COOL-DOWN
Every program ends with a ten-minute cool-down cycle that is designed to reduce wrinkling. This means the
clothes will be cool when you remove them from the dryer, rather than scorching hot. During the last cooling
stage, the On/Off indicator lamp goes off.