Euro-Pro EP8001 Iron User Manual


 
INSTRUCTIONS FOR USE
Your new Ironing System offers the ultimate in modern ironing. Read carefully all the important
safeguards (page 1) and all the instructions in the user manual before using your Ironing
System. Follow all the instructions.
1. WARNINGS:
Never leave the unit unattended while plugged in. Always disconnect from electrical power source.
You must always unplug (disconnect) the unit when you have finished using it and:
A) Before opening the Safety/Filler Cap (1).
B) Before any cleaning or maintenance.
C) Before filling and emptying the water tank/steam generator (5).
D) When you leave the room, even if only for a few minutes.
Always place the iron on the iron rest (6) when not in use.
Never use the ironing system if the iron or the steam generator have been dropped. To avoid risk of
electric shock, do not disassemble or attempt to repair the ironing system. Return the unit to
EURO-PRO Operating LLC. (see warranty) for examination, repair or replacement.
Do not stretch out the power cord (8) and/or steam hose (7) while ironing. Do not use the appliance if
an power cord (8) and/or steam hose (7) is damaged. If the power cord (8) or steam hose (7) show
signs of wear or damage, please return the unit to EURO-PRO Operating LLC (see warranty) for
examination, repair or replacement.
Read the “IMPORTANT SAFEGUARDS” listed on page 1 and all special instructions and follow
carefully.
2. DRY IRONING:
1. Place your steam generator on a solid flat surface.
2. Plug in unit. Press the Iron ON/Off Rocker Switch (4) which lights up to indicate that the iron is “ON”.
3. Set the Temperature Dial (B) according to the garment label or use the temperature setting table
included in the user’s manual as a guide.
4. The Iron Heat Indicator Light (A) will go on and will turn off when the iron has reached the desired
temperature.
5. You may iron without steam at any temperature setting.
3. IRONING WITH STEAM:
1. Plug the appliance into a 110/120 V electrical outlet.
2. Press the Iron ON/Off Rocker Switch (4) to the “ON” position. Press the Steam ON/OFF Rocker
Switch (3) to activate steam generator.
3. When planning to use steam, make sure to set the Temperature Dial (B) in the area designated for
use with steam. i.e. between the two “” and three “” dots on the Temperature Dial (B).
(See temperature setting table included in the user’s manual as a guide.)
4. The Steam Ready Light (2) will come on in 8-10 minutes indicating steam is available. The Steam
Ready Light (2) will go on and off while the generator is in use.
5. Press Steam Button (C) to activate the steam release.
NOTE: Before ironing, point iron away from table, press steam button (C) to clear initial condensation.
WARNING: Never direct steam from the iron at yourself or another person. Special care must be
taken when the iron is used in a vertical position. The steam is very hot and can cause burns.
4. CONTINUOUS STEAM BUTTON:
NOTE: Trying to use steam before the Steam Ready Light (2) is “ON” can cause water drops
in the stem coming out of the iron.
If you need a steady steam supply, press the Continuous Steam Button (D) down and then push it
backwards to lock the Steam Button (C) in. To unlock, press the Continuous Steam Button (D) down
again and push it forwards.
5