Filter
Top Products
STORAGE/CLEANING AND MAINTENANCE
STORAGE:
• Always unplug the power cord from the wall outlet when not in use.
• Always store in a dry place away from children’s reach.
• Always drain the Water Tank/Steam Generator (5) before storing.
• Always let your ironing system cool completely before putting away.
• Do not allow the electrical cord and steam hose to touch hot surfaces.
• Wrap the cord loosely around the ironing system when storing.
CLEANING/MAINTENANCE:
• The cord must be unplugged from the wall outlet before starting to clean any part of the
appliance.
• Make sure that the Iron and Steam Generator are COLD before starting to clean. Allow
at least four (4) hours for the unit to cool after it has been used.
• Make sure that all steam has been emptied (released from the steam generator) before
opening the Safety/Filler Cap. (Follow instructions on page 6 Section A for releasing
steam.)
IRON:
• Clean the steam iron only when it is cold.
• Never immerse the steam iron in water or any other liquids.
• Do not use scouring pads, abrasives or harsh cleaners.
• Prepare a paste using mild scouring powder and a little water. Apply a small amount of
the paste to the soleplate with a damp cloth. Rub the soiled area and then wipe clean
with a clean damp cloth.
• If using soleplate cleaners, make sure that you follow label instructions.
• Use a soft cloth dampened with water and mild household detergent to wipe the outer
shell of the iron.
• Dry soleplate and thoroughly after cleaning.
STEAM GENERATOR:
We strongly recommend using demineralized/distilled water to insure optimum performance
and maximize the life of your steam generator.
If you are using demineralized/distilled water, the steam generator should be cleaned once
every 6 to 12 months, depending on the frequency and duration of usage. If you use regular
tap water, the steam generator should be cleaned once a month.
1. Make sure that there is no steam remaining in the steam generator. Follow the
instructions for emptying/releasing steam from the steam generator on page 6 Section A.
2. Make sure that the steam generator is cold.
3. Remove the Safety/Filler Cap (1), carefully following the instructions to make sure that the
unit is cold by slowly turning the cap to allow any remaining steam to escape. If any
steam is released, stop and follow instructions for emptying/releasing steam on page 6
Section A.
4. Fill the tank with water as per instructions on Page 6.
5. Plug in the unit. Switch on the system by pressing the Iron ON/OFF Rocker Switch (4)
and the Steam ON/OFF Rocker Switch (3). DO NOT LEAVE UNIT UNATTENDED.
6. Allow a few minutes until the water starts to boil without the Safety/Filler Cap (1) on. DO
NOT LEAVE UNIT UNATTENDED.
7. Put the Iron ON/OFF Rocker Switch (4) and the Steam ON/OFF Rocker Switch (3) in the
“OFF” position. Unplug the unit from the electrical outlet.
8. Allow the unit to cool completely.
9. Empty the water contained in the generator.
10. YOUR STEAM GENERATOR IS NOW CLEAN.
9