Filter
Top Products
11
TO ADD WATER
• Unplug iron from the electrical outlet.
• Follow instructions to empty the iron.
• Then, follow the instructions for filling the iron.
Following this procedure will ensure that you do not overfill the iron.
SELF-CLEANING
In order to remove calcium and built-up particles, the self-cleaning system should be run at least
once a month.
• Fill the watering beaker provided to the half-full mark and then pour into the water reservoir.
• Set the variable steam control (4) to the no steam position.
• Insert the main plug into the wall socket.
• Set the temperature control dial (9) to the maximum temperature.
• Wait until the thermostat light (3) goes off and steam iron has reached preset temperature.
• Remove the plug from the wall socket.
• Hold the steam iron horizontally over a sink.
• Turn the variable steam control (4) to “Self-Clean ” position. Hot water and steam will
be emitted from the soleplate. Swing the steam iron lightly back and forth gently to allow lime
and dust particles to come out.
• When the water reservoir is empty, shift the variable steam control from “Self-Clean” position
to “0”.
• Stand the iron upright and insert the plug into the wall socket to let the iron heat up again.
• Move the iron over a clean cotton cloth to clean the soleplate and let the remaining water on
the soleplate evaporate.